Send a private message to dawhiz. See post You need a blade at least mm long like a hacksaw blade or something a bit stronger that long. I started with the tiny hacksaw in the picture of step 4 but could not finish the cut with it. And does this kit include all the nessesary hardware to relocate the coolant tank? Inlets are done!
These RB N54 Turbo High Flow Silicone Inlets are the most versatile, performance oriented, cost effective, and easiest of installation inlet system available today. The " end fits nice and snug over the OEM style inlet snouts of most all stock frame turbo systems available. Colonel.
Video: 335i rb inlet Should You Get Inlets On Your N54 BMW? YES!
Australia. Rep. 2, Posts. Drives: i e92 6spd man. Join Date: Jul Location: Darwin.
DIY RB Silicone Inlet Install i International Turbo Racing Discussion
iTrader: (0). RB Inlet DIY. e90 i pure stgae 2 DD turbos, rb inlets, bms 4 bar map sensor. Jb4 with mhd hybrid e85 back end flash, vrsf down pipe vrsf 7".
These are now out for 3rd party test fitting and feedback as we try to button up contents and cost of the kit.
Just cut the rear inlet from the bottom, cut it pretty much where it turns 90 degrees up. When you slide it in try pushing it down diagonally towards turbo. When you put the clamp on the snout make sure you can get to it to tighten it. User Name. Common sense would suggest that the gains to be had on the stockers would be minimal as the airflow rate of the OEM turbos is quite a bit less than RB's.
Not More Inlet options!! RB EVO Style Inlets Sneak Peak!!
Get a hack saw or similar to cut through the inlet on the top right and near the snout.
6, Posts. Drives: Space Grey E92 i 6MT. Join Date: Jul
Step 5 Installing the inlet. One choice is to cut a notch out of your wastegate bracket to accommodate the worm gear from the clamp so it can be secured closer to the turbo.
Air filter and diverter valve should be disconnected already. This is huge progress for the n54 platform, can't wait to have them installed.
AWHP/AWTQ TFT Inlets + RB Turbos + BQ/Wedge Tuning
B101 BARRIE ADDRESSES
|Find More Posts by AndyW. Pull the inlet down enough to slide onto the snout and feel around until you can pull the clamp over the silicone.
Thanks, Rob Attached Images. I believe pure made one and has it for sale now. Lieutenant Colonel.
Video: 335i rb inlet Chris' BMW 335i RB Twin Turbo Dyno @ Sound Performance
Tie the end of the inlet up with sticky tape to get it over one of the lips.